About lines, curves and shapes

When you want to draw vector shapes and curves you'll need to use the Pen, Pencil, Brush and Shape tools. Editing curves and shapes is done with the Node tool or the as you draw.

Line example

Curves and lines

A curve is an open path that has a distinct start and end. These end points are defined by nodes. A curve with just two nodes is referred to as a line.

The path between nodes is known as a segment and can be straight (A) or arched (B). Complex curves are created from multiple nodes connected by segments (C). Lines and curves generally have a stroke applied.

Segment types

The type of node controls the connected segments. There are three basic types of node:

Node types

When drawing curves, any combination of nodes can be used. Each node also has control handles. These appear when the node is selected. The length and slope of the control handles determine the shape of the segment. A node can be edited at any time.

Direction handles

Shapes

A shape is a closed path with no discernable start or end. It is made up of multiple nodes and segments.

Close path

You can also easily create geometric shapes using the Shape tools. These have special properties that enable you to quickly create otherwise difficult to draw shapes, such as circles, rectangles and polygons.

Filling self-intersecting shapes

Shapes which have been constructed using self-intersecting lines can be filled in two different ways: Alternate or Winding. The former mode applies a fill or transparency to contiguous sections alternately along the lines. The latter fills all sections encompassed by the shape's outer lines.

Fill Mode example

Alternate and Winding Fill Modes respectively.
To set Fill Mode:

SEE ALSO: